Waterjet cutting systems
news
If you are looking to increase your profit margin with a minimal investment, our cutting systems will open new doors for you. The HYDRAjet Cutting System is a natural addition to your existing business’s capabilities.
Waterjet vs. EDM
  1. Five to 10 times faster in parts less then 1” thick
  2. No heat affected zone
  3. Works well in non conductive materials such as glass stone and plastic.
  4. Can pierce material directly without the need for a pre-drilled starter hole
  5. Can produce large parts at a minimal cost
  1. Extremely precise parts are possible
  2. Very thick parts (over 12”) can be made
  3. Intentional taper can be put into a part for die clearance and uses.
  4. Simple and rapid programming and set up with minimal fixturing